Facts 

The plane is covered in Super Coverit fabric. Rib stitching is from small sections of fishing line glued to the plane. Scale pinking tape’s from Gary at pink-it.net and most of the graphics were from getstencils.com. Plane is painted in Exterior latex house paint matched to federal paint chips. 

I’m using the old inflatable Dubro cub wheels with a set of Robart main landing gear. Proctor turnbuckles, are used on the ailerons, and ruder with a pull pull setup. Custom tail wheel to match the original one, along with custom hinges on the ailerons. The inside is detailed out with all the details that are in the full scale plane. When a control surface is moved the controls in the cockpit move with it. 

A Scale Contentianl cylinders are installed to cover up the Valley View RC 26CC Over 300 screws hold all the windows and framing work together for the greenhouse section. 

For controls I’m using Spektrum DX18 Gen2 and AR10360T RX with aSPM9747sat.  I’m running full onboard telemetry with heat, RPM, engine, and RX pack voltage.   Using a Futaba S-U300 for throttle, Spektrum A6380 for rudder and elevator.  Savox SC-1251 in each wing half for aileron control by a pull pull setup. I run the pull pull setup from a pulley I made on top of the servo.  Have a Rcexl kill switch on the engine.   All linkages and horns on the surfaces are scaled from the full scale. I’m running dual switch / battier setup using LiFe 2s 2250 mah packs. For ignition I’m using a 5 cell NiMH 1400 mah pack.